• ​​Exactly same quality standard as brand factory original
• High quality red copper pipe
• Products conform to R410A refrigerant usage standard
• In-pipe residue achieve international advanced level

KA8243/8245 control module enables to control inverter type outdoor unit without the needs of airconditioner

factory produced indoor unit.It gives possibility to control outdoor unit capacity and state to produce heat or cooling for AHU or water heater/cooler.

• ​Suitable for all voltage in the world
• Very quiet & non vibration
• Easy assemble
• CE certificate

• ​Suitable for commercial airconditioner installation
  
• Suitable for airconditioner installation

KA8243/8245 control module enables to control inverter type outdoor unit without the needs of airconditioner

factory produced indoor unit.It gives possibility to control outdoor unit capacity and state to produce heat or cooling for AHU or water heater/cooler.

• ​Compressor capacity range is wide
• Refrigerant R22/R407/R410A/R134A/R40A/R290/R32
• Support a wide variety of power source
• 
  

​​​​​ REED​ 

• One stop solution
• More than 10 years HVAC experience
• Whole unit factory quality standard
• ​​Wide range resource

Water pump series

• Bracket 
• Air conditiner installation Accessories Ducts catalogue
• Air disffuser

• It's composed of a heating wire coated with silicone rubber c​haracteristics soft,energizing and heating uniformly,resistant to moisture .it can be long​-term used under 40℃-200℃ ​​condition​​​​

• Energy-saving​ 
• Environmenal protection
• Safety and comfortable
• Long life expectancy
•  Health care

KA8345/KA8346/KA8347control module enables to control M factory

Mini VRF and VRF outdoor unit without the needs of airconditioner factory produced indoor unit. It gives possibility tto control VRF outdoor unit capacity and state to produce heating or cooling for AHU or water heater/cooler.

KA8345/KA8346/KA8347control module enables to control M factory Mini VRF and VRF condensing unit capacity between 0-10%-100%by external input 0-10VDC signal.

Dry contact signal is used to control outdoor unit to work in cooling or heating mode.

Built-in SANHUA electronic expansion valve.

This control box can only connect one 

indoor unit. Indoor unit capacity range is

between 7.0KW and 50KW.

When outdoor-air processing units are

connected,the total connection capacity must be wihtin 50%to 100% of that of the outdoor units.

when only connected with fresh air processing unit,overmatch is not allowed.

The installation and operation of VRF outdoor units as well controller must be done according to VRF manuals